Ball Bearing Drawer Slides FAQ

You have so many to choose from. What is the best choice of slides for my application?

Please take some time to look at the type of application shown for each group of slides on our Ball-Bearing Drawer Slide Comparison Guide. Knowing the type of application you have (what type of drawer or shelf you're using the slide for) will help you choose which group of slides is best to select from.

1. What does the length listed refer to?
2. What is meant by extension?
3. What is over-travel?
4. How are load ratings calculated?
5. What does the term disconnect refer to?
6. What is side space?
7. What does a 32mm hole pattern feature refer to?
8. Do I need any special tools to mount slides?

Go to the Ball-Bearing Drawer Slides Section

See the Ball-Bearing Drawer Slide Comparison Guide Page

What does the length listed refer to?

The length noted will be the length of the slide when it is completely closed. You will need a minimum of this amount of space in your cabinet in order to mount the slide.

Back to Top

What is meant by extension?

This refers to how much of the slide will pull out or how much travel distance the slide is capable of. A full extension slide will extend out the full amount of the length of the slide (as example: a 20" long slide will come out 20"). A 3/4 extension slide will extend 3/4ths of the length of the slide (as example: a 20" slide will come out 16").

Back to Top

What is over-travel?

This means that a slide will pull out or travel beyond a full extension (as example: a 20" long slide, with 1" of over-travel will pull out 21").

Back to Top

How are load ratings calculated?

Manufacturers test their slides according to industry standards for how much weight they are capable of carrying. Tests are typically based at an 18" extension and 50,000 to 75,000 cycles of moving the drawer in and out. Ratings include a 100% static load safety factor (this means the slide will always be able to hold a minimum of the load rating in any position when the slide is stationary).

Back to Top

What does the term disconnect refer to?

This refers to how the parts of the slide come apart. Half of a slide will attach to the cabinet, the other half will attach to the drawer. If you want to remove a drawer to clean you will need to disconnect the drawer half from the cabinet half of the slide in order that the drawer can be removed from the cabinet. Different groups of slides will have different types of disconnect features for removing one half from the other. Some slides may have no disconnect feature.

Back to Top

What is side space?

This refers to how thick the slide is. A slide that mounts on the sides of the drawer will take up this much space on each side. The side space is the minimal amount of space you will need to allow on each side of the drawer when laying out your cabinet design.

Back to Top

What does a 32mm hole pattern feature refer to?

Many of the Accuride ball bearing slides offer this feature. It refers to the placement of the screws holes used to mount the slides. A 32mm hole pattern has the screw holes placed 32 millimeters apart on center.

Back to Top

Do I need any special tools to mount slides?

You may wish to purchase one of the JIG-IT™ templates, which are listed with many of the groups of slides. This template works with a self-centering bit for lining up perfectly centered holes. While it is possible to mount the slides without a template, using one will make the installation easier and faster.

Back to Top

Go to the Ball-Bearing Drawer Slides Section

See the Ball-Bearing Drawer Slide Comparison Guide Page